Difference between revisions of "Revision: Benderlink for BLM 3.2"
From ATTWiki
| Line 3: | Line 3: | ||
===[[image:Check.jpg|25px]] New Recognition of Variable Radius Bending === | ===[[image:Check.jpg|25px]] New Recognition of Variable Radius Bending === | ||
| − | [[image:Benderlink_blm_variableradius1.jpg]|500px] | + | [[image:Benderlink_blm_variableradius1.jpg]|500px]] |
<table cellpadding="15" width = 650> | <table cellpadding="15" width = 650> | ||
Revision as of 20:40, 7 December 2007
New Recognition of Variable Radius Bending
[[image:Benderlink_blm_variableradius1.jpg]|500px]]
| BLM benders can bend using draw bending or push-bending. BLM refers to push-bending as "variable radius bending." This version of Benderlink can recognize large radius push-bends and skip corrections to straights before and after push-bends. Also the bend angle of each push-bend is left untouched. |
|
New Confirm File Overwrite
|
Benderlink now requests operator confirmation when the operator is asking for a file overwrite during SAVE. |
|
New Convert SV Part Number to UPPER Case
|
Benderlink now automatically converts all SV part numbers to upper case when converting from BLM data. |
|
Other Pages
Main Benderlink Wiki page
Main Benderlink for BLM Wiki page
