Difference between revisions of "Benderlink for Pines"
| Line 1: | Line 1: | ||
[[image:Blink_pines_logo.jpg|300px]] | [[image:Blink_pines_logo.jpg|300px]] | ||
| + | [[image:LASERVISION.jpg|right]] | ||
| + | [[image:PINES_bender.jpg|right]] | ||
| − | + | =About= | |
| + | Benderlink for Pines is software that connects PINES TS2000 controls with Eaton Leonard Vector Laservision measuring centers. | ||
| − | [[image: | + | [[image:Blinkpines_v2_mainscreen.jpg]|300px]] |
| + | |||
| + | The software installs directly on the operator station of the Pines TS-2000 controls. It is designed to interact directly with the control. The designer of the TS-2000 included a "Laservision" button that loads and calls to Benderlink for Pines. | ||
| + | |||
| + | =Versions= | ||
| + | |||
| + | ==Version 1.x== | ||
| + | [[image:Blinkpines_v1_mainscreen.jpg|200px]] | ||
| + | Version 1 of Benderlink for Pines communicated with Laservisions using the ATT protocol. The ATT protocol was a special protocol that required customers to purchase and install an upgrade to the Vector Laservision. | ||
| − | + | ==Version 2.0== | |
[[image:Blinkpines_v2_mainscreen.jpg]] | [[image:Blinkpines_v2_mainscreen.jpg]] | ||
| + | Version 2 is designed to communicate using the standard Eaton Leonard Velog, EL-2000, and Premier protocol. This protocol is available on every Eaton Leonard measuring center. No upgrade is necessary. | ||
Revision as of 00:42, 1 May 2008
Contents |
About
Benderlink for Pines is software that connects PINES TS2000 controls with Eaton Leonard Vector Laservision measuring centers.
[[image:Blinkpines_v2_mainscreen.jpg]|300px]]
The software installs directly on the operator station of the Pines TS-2000 controls. It is designed to interact directly with the control. The designer of the TS-2000 included a "Laservision" button that loads and calls to Benderlink for Pines.
Versions
Version 1.x
Version 1 of Benderlink for Pines communicated with Laservisions using the ATT protocol. The ATT protocol was a special protocol that required customers to purchase and install an upgrade to the Vector Laservision.
Version 2.0
Version 2 is designed to communicate using the standard Eaton Leonard Velog, EL-2000, and Premier protocol. This protocol is available on every Eaton Leonard measuring center. No upgrade is necessary.
