Difference between revisions of "Configuring Machine Lube Settings"
From ATTWiki
(→Where to find it in CNC Bender) |
(→Where to find it in CNC Bender) |
||
| Line 2: | Line 2: | ||
==Where to find it in CNC Bender== | ==Where to find it in CNC Bender== | ||
| − | The configuration is displayed in an editor in the Low Level menu, CNC Processor CFG tab. | + | The configuration is displayed in an editor in the Low Level menu, CNC Processor CFG tab.<br> |
| + | <br> | ||
| + | [[image:cncbender_cncprocessor_config_file.jpg|400px]] | ||
==Where to find it on the Hard Disk== | ==Where to find it on the Hard Disk== | ||
Revision as of 20:21, 28 January 2009
The CNC Processor configuration file contains the values necessary to adjust the machine lube settings.
Contents |
Where to find it in CNC Bender
The configuration is displayed in an editor in the Low Level menu, CNC Processor CFG tab.
Where to find it on the Hard Disk
The file is available in the c:\cnc\config folder in the file "CNCProcessor.cfg".
"Machine Lube" Section
The settings in this file are separated by sections with section names in square brackets like this:
[Machine Lube] Machine Lube Duration=5000 Lube Machine At Bend Count=100 Pulse Machine Lube Pump=1 Watch For Machine Lube Complete Input=0
The four values above control the machine lube features in CNC Bender.
Read details for each of the values here:
- Machine Lube Duration
- Lube Machine At Bend Count
- Pulse Machine Lube Pumpt
- Watch For Machine Lube Complete Input
Other Pages
Back to
