CNC Bender v11-20090408

ENHANCED - Moved MANDREL CYLINDER ENABLE option from OVERALL to BEND Rows and RENAMED

This change allows the mandrel to be switched ON or OFF individually for any bend row rather than for every bend row.

The option was MOVED and RENAMED to "MANDREL CYCLE ENABLE" because we cannot no longer anticipate that all mandrel actuators will be cylinders. For example, it is possible that we may use geared electric servo motors for the mandrel.

This new PER BEND feature is critical for mandrels in rectangular or square tubing that rotate 90 degrees, but the mandrel can only bend in one of the two planes.



This is the option list with the new title:



When loading older CNC Bender part files, the new Bend row mandrel option will always be set to OFF. To set the mandrel ON in every row, set the value to ON in one row, then press the "Copy Value to All Rows" button.

CHANGE - To Mandrel Early Advance in Prebend Logic

Now the Mandrel Early Advance is activated only if the MANDREL CYLINDER ENABLE is ON in the first bend row.

CHANGE - Added "RETURN" before "Angle" in "Early Mandrel Forward At Angle"

This option title change to "Early Mandrel Forward at Return Angle" removes an ambiguity on when this feature will take effect. The word "Return" indicates that it happens when the bend arm is RETURNING to setup for the next row.

Other Pages

• Back to CNC Bender
• Back to CNC Bender Software Updates
• Read about Push Bending
• Read about Push Bend Profile Tables