CNC Bender v11-20090928

NEW - Simultaneous Absolute Rotate DURING Final Feed Clearance

This version of CNC Bender uses secondary process lists to set the Absolute Rotate position in the chuck while the Final Feed Clearance move is in action.

This can trim seconds off the part cycle - especially in cases where the Absolute Rotate Offset Position is far from zero degrees.

NEW - Separate Part Release Mandrel Retract Command for Faster Cycles

Now the final Mandrel Retract command is unique from all other Mandrel Retract commands. This allows for treating the final Mandrel Retract with a special timer or to watch a prox. switch in order to ensure that the mandrel is completely home before fully retracted.

Since this feature allows CNC Bender to treat the in-bend mandrel retractions separately from the last mandrel retraction, you can increase a pause after the final mandrel retraction while decreasing or eliminating the pauses or prox switch examinations in the in-bend mandrel retractions - thus shaving cycle time.

In-Bend Mandrel Retract Command	MandrelRetract
New Part Release Mandrel Retract Command	MandrelRetract_PartRelease

Other Pages

• Back to CNC Bender
• Back to CNC Bender Software Updates
• See CNC Bender General Information