CNC Bender v12-20100611

NEW - CNC Bender Direct-Axis Jog with Joystick or Pendant

CNC Bender can now respond to a joystick or pendant buttons when direct-axis jogging.

NEW- Direct Axis Jog from INPUT Options

The low level general options list contains three new options: ENABLE, JOG+ Input Name, JOG- Input Name. If this feature is enabled, then the input names are used to lookup the input points in the CIO dictionary.

REPAIRED - Single Radius Carriage Shifting

Single radius carriage shifting is now re-enabled in this version.

REPAIRED - Direct Axes Jog Buttons Stick Down

If the Immediate Message box displays while an operator is pressing a JOG+ or JOG- button in direct axes jog mode, then CNC Bender would never allow the jog button to come up. This has been resolved.

REPAIRED - Automatic Feed Adjustment During Part Load

The automatic feed adjustment feature works by advising operators that incoming part data was from another bender with a different bed length. We discovered that two of the Tool page options were not being changed properly. This is corrected.

Other Pages

• Back to CNC Bender
• Back to CNC Bender Software Updates
• See CNC Bender General Information
• See Teach Mode
• See Custom Commands