VTube-LASER v1.63

Revision 1.63 Back to VTube-LASER

NEW: Select and Configure any number of Reports

The Report menu was redesigned so that operators choose from a list of report templates to show any one of several reports. Edit the list (Add, Delete, Move the template up or down). Edit any template in the included Notepad++ editor (installs with v1.63). Explore the folder that contains the templates. Give the report template a new name. There is no limitation on the number of templates allowed. The report template setup is stored local to the computer (not in project files).

Other Changes

Updated the graphics engine for faster redraws. Added more report values - master length, measured length, delta between measured and master, bender setup LRA Updated the manual and help file.

NEW: Multiple Point Qualification End Scan

VTube-LASER now uses multiple points to qualify the end-scan. This gives it better protection against outlier points. A new End-Scan Fit window gives information about how many points were used in the end-trim, and the span of all the point positions. Higher point counts with lower spans indicate a better data set for end-trim.

REPAIR: Diameter and Wall Detection for STEP Mode

See VTube-STEP v1.62 for details.

Other Changes

The A End and B End OFFSETs other than ZERO caused a problem where end-scans would never be qualified. This has been resolved in this version.

Issues with this version fixed in newer versions

No known issues

Other Pages

• Back to VTube-LASER

VTube-LASER Training Video - How to perform effective end scans.