CNC Bender v12-20110525

v12-20110525 Back to CNC Bender Software Updates

ENHANCED - Changes to Logic

Chuck Close/Open Skip in Post Bend - for special teach mode unloading Processor checks for special internal command in processlists - which is required even in custom processlists: [BEGIN RUN AGAIN] Allow mandrel to advance in MANUAL page even if clamp or pressure die are closed.

ENHANCED - Changes to Loading

CNC Bender can now be loaded from the Start Menu at Windows boot without failing to find the hardware key

FIX - Default Mode Value When in Toolbox

The default mode index for dynamic options is now always the first item when in the toolbox

Other Pages

• Back to CNC Bender
• Back to CNC Bender Software Updates
• See CNC Bender General Information
• See Teach Mode
• See Custom Commands