CNC Bender v12-20111229

From ATTWiki
Revision as of 18:03, 29 December 2011 by Mcone (Talk | contribs)

Jump to: navigation, search

v12-20111229

Cncv12procontrol withteachmode.jpg

Check.jpg REPAIR - Pressure Die Interference Zone Collision Message

  • The pressure die interference logic would stop the bending with a collision message if a Feed-Bend would take the chuck into the pressure die zone and the PDA was a servo axis.


  • Now if the PDA is a servo axis, then the potential for collision is ignored. This will assume that the pressure die is moving forward.


Other Pages