Lube Machine At Part Count

What is It?

This property allows CNC Processor to switch the mandrel lube output to ON after a pre-programmed number of parts have run.

Value

The value is set to milliseconds like this:

Lube Machine At Part Count= 500

In this case, the machine lube will activate after each 500 parts run on the machine.

Alternative Properties

Two alternative properties are...

• Use Bend Count For Machine Lube
• Lube Machine At Bend Count

If Use Bend Count For Machine Lube value is set to 0 then the Lube Machine At Part Count property will be used. Set the Use Bend Count For Machine Lube property to equal 1 to set CNC Processor to use the "Lube Machine At Bend Count" property.

The Lube Machine At Bend Count property is used to set the bend count for machine lube. --Mcone 23:30, 19 July 2006 (EDT)