Cable Spec 33

From ATTWiki
Revision as of 20:50, 17 September 2012 by Mcone (Talk | contribs)

Jump to: navigation, search

For use inside Benderlink Ethernet Modules with current loop electronics.

Cable33 closeup.jpg

Use for simulating the PREMIER (Bender) side only.

Cable33.jpg

Wiring schematic:
Cable 33 wire scheme.jpg

In this configuration, it is necessary to use a version 2 CB-EL1 board with the jumpers set to "BND" to simulate the bender side of the connection. Use this setup for connecting a non Eaton Leonard bender to an Eaton Leonard Vector measuring center.
Cb-el1 bendermode.jpg


Other Pages