CNC Bender v12-20120728

v12-20120728 Back to CNC Bender Software Updates To download the update see the support page.

Enhanced HALT in Processor for Servo Motion

This version implements a stronger HALT in CNC Processor to be sure motion commands are halted during E-Stop. This will ensure that Processor does not continue to move the bender during an E-Stop type event.

Ceased Reporting Error for [BEGIN PROGRAM] Label

When this label was encountered in the Processor, any error would be reported in all cases. This has no value - so it is now ignored completely.

Other Pages

• Back to CNC Bender
• Back to CNC Bender Software Updates
• See CNC Bender General Information
• See Teach Mode
• See Custom Commands