CNC Bender v12.1.1

v12.1.1 - August 26, 2013 Back to CNC Bender Software Updates See CNC Bender Customer Service Page for an update.

FIX: FRB Clear Part Fixed

CNC Bender would save parts after a FRB clear by default in the c:\cnc\config folder. This was repaired so that it saves inside the the correct parts folder.

NEW: Processor Now Checks to See if Inputs are Internal

CNC Processor can now check if an input is an internal input that is not connected to a physical input. This is used for setting and reading states inside the Processor without using actual physical I/O.

FIX: CNC Bender Benderlink Fix with Laservision

CNC Bender Benderlink would sometimes return an out-of-bounds error after receiving Laservision data. This was related to setting the first straight adjustment value to zero. It has been resolved.

ENHANCED: CNC Bender Benderlink Can Emulated Hyprex Laservision

CNC Bender Benderlink can emulate the Hyprex Laservision mode which handles 21 characters in the part name rather than 14 characaters.

Other Changes

Forward PDA Outputs are cleared when the operator enters CYCLE HOLD. No other outputs are changed when this event occurs.

Other Pages

• Back to CNC Bender
• Back to CNC Bender Software Updates
• See CNC Bender Customer Service Page for an update.
• See CNC Bender General Information
• See Teach Mode
• See Custom Commands