CNC Bender v12.7

v12.4 - January 20, 2014 Back to CNC Bender Software Updates See CNC Bender Customer Service Page for an update.

ENHANCED: Load and Start Positions with Bend Arm Motion Option (in Pre Bend)

CNC Bender Pre Bend has a new option called "Arm to Home Mode" that controls when the bend arm returns home before bending begins. The goal is optimization of the cycle. These are the choices: 1: Before Move to Load 2: During Move to Load 3: After Move to Load 4: After Chuck Close 5: During Move to Start 6: After Move to Start Use this in conjunction with the PostBend Release command where you can turn off the bend arm return during release.

ENHANCED: Post Bend Release Mode Has a New Mode

A new ninth option is added to the Post Bend Release Modes. This mode can be used with the new Arm to Home Mode to switch off the arm homing at the end of the cycle.

Other Changes

New COMDEFs were added to work with the new Arm To Home Mode above. The commands are:

Other Pages

• Back to CNC Bender
• Back to CNC Bender Software Updates
• See CNC Bender Customer Service Page for an update.
• See CNC Bender General Information
• See Teach Mode
• See Custom Commands