CNC Bender v10-20070726b
Contents |
REVISION Information
10-20070726, July 26, 2007
FIXED: BeyondLastCycleTime Variable
About
The BeyondLastCycleTime variable used in the Constant Run Processlist is designed to allow CNC Bender to take action if the the bender is a certain time beyond the last cycle time. A CYCLE is considered any JOG, STEP, or AUTO mode action.
Example code from Constant Run Processlist:
[if] and, BeyondPowerOnTime=2000, BeyondLastCycleTime=300000, BeyondLastCycleTime=not(301000)
[display]AUTOMATIC PRESSURE Off After 5 Minutes HydraulicPressureAllOFF
[end]
Repair
This variable was not being updated properly in the STEP or AUTO modes. In versions v10-2007vvvv of CNC Bender, the benders would shutdown in the middle of bending after a five minute period because it believed that the bender was idle (which it was not).
This has been repaired.
FIXED: RECAPTURE
About
Recapture allows CNC Bender to recapture a part with the chuck after having previously release it.
Repair
Compiling a processlist with recapture to memory create a compilation error that stopped the transfer of data into CNC Processor.
This has been resolved.
First Installed To Benders
- SMT 12652 - VB150 - Triple Radius Head Shifter
- SMT 15687 - VB150 - Triple Radius Head Shifter
- SMT 15688 - VB150 - Double Radius Head Shifter
--Mcone 14:59, 3 August 2007 (EDT)
