Benderlink for Pines

About

Benderlink for Pines is software that connects PINES TS2000 controls with Eaton Leonard Vector Laservision measuring centers.

TS-2000 Control to Vector 1 Laservision

The software installs directly on the operator station of the Pines TS-2000 controls. It is designed to interact directly with the control. The designer of the TS-2000 included a "Laservision" button that loads and calls to Benderlink for Pines.

Versions

Version 1.0

Version 1 of Benderlink for Pines communicated with Laservisions using the ATT protocol. The ATT protocol was a special protocol that required customers to purchase and install an upgrade to the Vector Laservision.

Version 2.0

Version 2 is designed to communicate using the standard Eaton Leonard Velog, EL-2000, and Premier protocol. This protocol is available on every Eaton Leonard measuring center. No upgrade is necessary.