Pro/ENGINEER

With the Piping and Cabling Extension, Pro/E can output FIF files.

FIF Translator can convert convert data from Pro/E into data that is compatible with most benders in the industry.

Known Problems for Pro/E Calculation of Centerline Data

We have discovered that when Pro/E encounters a 180 degree bend that it incorrectly calculates the centerline XYZ coordinates for the FIF data that it builds. Rather than attempting to build two points for the 180 degree bend, it shows 1 point for that bend. The resulting centerline tube is usually nothing like the actual tube shape.

This is a normal problem when developers of tube fabrication software forget to test special cases - like 180 degree bends - in their algorithms.

In these cases, the YBC or LRA bender data can still be extracted from the FIF file since this data is correct. For example Benderlink for Chiyoda and Benderlink for KEINS allow operators to choose which set of data, the XYZ centerline data or the YBC/LRA bender data, is imported.

From FIF YBC Data	From FIF XYZ Data
This is the image of a part that contained a 180 degree bend that was exported from Pro/E. The shape is based on the YBC data from the FIF file	This is the image of the same part in the same FIF file that was defined by the the XYZ centerline data in the FIF file

Other

See the Wikipedia site for Pro/ENGINEER

See the PTC Web Site Page for Piping and Cabling