Benderlink for Flexbending Systems

The Wayne Trail Flexbending Systems is one of the most complex bender systems available anywhere. It uses multiple sub-benders that performs bending from both ends of the tube at the same time. It is completely programmable for changing parts in seconds. Benderlink for Flexbending Systems simplifies the setup and correction of the system through a series of sophisticated setup screens that convert standard bender data to the Flexbending System style data. It allows you to enter XYZ centerline data, convert that data to standard bender data, then convert that data to Flexbending Systems data through sophisticated mapping screens that teach the bender how to assign the standard bender data to its sub-benders. After the initial mapping setup is complete, the software converts measuring center corrections automatically to steer the bender to a good part.

Protect Your Data: Password Protection

1. Login user control: Administrator, Supervisor, and Operator levels allow varying level of access and control
2. Logs show who made changes to the data and when

Save Hours: Powerful Bender Setup

1. Map the standard LRA bender data to the Flexbending System CYCLE data (Teaches the bender where each bend is placed in the bender)
2. Sophisticated rotation reports that quickly show how rotations are affected downstream from the current rotation - in order to prevent rotation axis overtravel
3. Setup the actual Flexbending Systems CYCLE data inside Benderlink very quickly
4. Setup function bits that control boolean options
5. Runs in the operator station - always available without another computer