CNC Bender v11-200900915
From ATTWiki
ENHANCED - Pressure Die Advanced Timer Choice in Processlist Builder
The pressure die advance timer choice in the Processlist Builder is now dependent on the Pressure Die Assist setup in the Low Level General Dynamic Options list.
For example, if the PDA Mode is set to Follower / No Prox, then the Processlist Builder will switch to use the new PressureDieAdvanceWithTimer Without PDA command like this:
PressureDieAdvanceWithTimer Without PDA = tim2:500, cto:6000
ENHANCED - File Path in FRB Page Synchronizes With Low Level Path Settings
When the part path in the low level File Paths menu,
the path also now automatically changes in the FRB page in Bender Data.
Other Pages
- Back to CNC Bender
- Back to CNC Bender Software Updates
- See Cycle Hold
- See Hopper Logic
- See Processlist
- See Secondary Processlist
