CNC Bender v11-20090928

NEW - Absolute Rotate During Final Feed Clearance

This version of CNC Bender uses secondary process lists to set the Absolute Rotate position in the chuck while the Final Feed Clearance move is in action.

This can trim seconds off the part cycle - especially in cases where the Absolute Rotate Offset Position is far from zero degrees.

NEW - Separate Part Release Mandrel Retract Command

Now the final Mandrel Retract command is unique from all other Mandrel Retract commands. This allows for treating the final Mandrel Retract with a special timer or to watch a prox. switch in order to ensure that the mandrel is completely home before fully retracted. With this feature you can remove the prox input check from in-bend mandrel retractions to make the cycle move more quickly.

In-Bend Mandrel Retract Command	MandrelRetract
New Part Release Mandrel Retract Command	MandrelRetract_PartRelease

Other Pages

• Back to CNC Bender
• Back to CNC Bender Software Updates
• See Cycle Hold
• See Hopper Logic
• See Processlist
• See Secondary Processlist