CNC Bender v11-20091201

Type of Upgrade: FLEXIBILITY The changes in this version are changes to CNC Bender for better flexibility.

NEW- Logic Allows Push Buttons to Toggle States

CNC Bender now allows logic to make a button into a toggle. For example, it is possible to use logic in the Constant Run processlist to switch a End Cycle push button on and off and illuminate the button according to the current End Cycle state.

NEW- Editor for High Speed Constant Run Processlist

The new editor in Low Level allows you to edit the new High Speed Constant Run Processlist.

NEW- Better Warning for Missing Processlists

Messages now display for missing High Speed Constant Run Processlist

UPDATE- Improved Grids in Dynamic Option Lists

New grid source with improvements for better performance.

REPAIR- Counter in RunPage is Updated to Zero When Run is Complete

The part count updated normally except when the Runlist Run is complete. This is corrected.

Other Pages

• Back to CNC Bender
• Back to CNC Bender Software Updates
• See CNC Bender v11-20091104
• See CNC Bender General Information
• See Absolute Rotate
• See Absolute Rotate Offset Position
• See Final Feed Clearance
• See Mandrel Retract
• See Mandrel Retract Part Release