CNC Bender v11-20091201

Type of Upgrade: FLEXIBILITY The changes in this version are changes to CNC Bender for better flexibility.

NEW- Logic Allows Push Buttons to Toggle States

CNC Bender now allows logic to make a physical momentary push-button into a toggle switch. For example, push the button to switch a state on, then push it again to switch the state off. For example, it is possible to use logic in the Constant Run processlist to switch a End Cycle ON and OFF using a push button. It is also possible to illuminate the button according to the current End Cycle state.

ENHANCED- Edge Triggerized [IF] Parameters Optimization

Edge triggers now reset properly when repeating the same inputs in multiple [IF] and [IFNOT] commands in the list of commands. If an edge triggerized input is true in an IF line, then the edge trigger is CLEARED - UNLESS the entire set of logic in that parameter line returns FALSE as a whole. In that case the edge trigger is set back to TRUE (it is SET). This allows for same edge triggered input to be used in several different [IF] and [IFNOT] blocks in the same processlist.

Other Pages

• Back to CNC Bender
• Back to CNC Bender Software Updates
• See CNC Bender v11-20091104
• See CNC Bender General Information
• See Absolute Rotate
• See Absolute Rotate Offset Position
• See Final Feed Clearance
• See Mandrel Retract
• See Mandrel Retract Part Release