CNC Bender v12-20110308

v12-20110308 Back to CNC Bender Software Updates

NEW - STEP Mode only

A new STEP Mode only option is available in low level. When enabled, CNC Bender will only run in STEP mode.

NEW - "Lost Home" Tolerance Increased

CNC Processor previously had zero tolerance for a HOME state that switches to OFF then back ON again quickly. CNC Processor will now recheck for a lost home state up to 25 times before switching the motor off and issuing a fault.

Other Pages

• Back to CNC Bender
• Back to CNC Bender Software Updates
• See CNC Bender General Information
• See Teach Mode
• See Custom Commands