Lube Machine At Part Count
From ATTWiki
Contents |
What is It?
This property allows CNC Processor to switch the mandrel lube output to ON after a pre-programmed number of parts have run.
Value
The value is set to milliseconds like this:
Lube Machine At Part Count= 500
In this case, the machine lube will activate after each 500 parts run on the machine.
Alternative Properties
Two alternative properties are...
- Use Bend Count For Machine Lube
- Lube Machine At Bend Count
If Use Bend Count For Machine Lube value is set to 0 then the Lube Machine At Part Count property will be used. Set the Use Bend Count For Machine Lube property to equal 1 to set CNC Processor to use the "Lube Machine At Bend Count" property.
The Lube Machine At Bend Count property is used to set the bend count for machine lube.
--Mcone 23:30, 19 July 2006 (EDT)
