Lube Machine At Part Count

From ATTWiki
Revision as of 03:44, 20 July 2006 by Mcone (Talk | contribs)

Jump to: navigation, search

Contents


What is It?

This property allows CNC Processor to switch the mandrel lube output to ON after a pre-programmed number of parts have run.

Value

The value is set to milliseconds like this: 

Lube Machine At Part Count= 500

In this case, the machine lube will activate after each 500 parts run on the machine.

Alternative Properties

Two alternative properties are...

<l>

  • Use Bend Count For Machine Lube
  • Lube Machine At Bend Count

    • </l>


    If Use Bend Count For Machine Lube value is set to 0 then the Lube Machine At Part Count property will be used. Set the Use Bend Count For Machine Lube property to equal 1 to set CNC Processor to use the "Lube Machine At Bend Count" property.

    The Lube Machine At Bend Count property is used to set the bend count for machine lube.

    --Mcone 23:30, 19 July 2006 (EDT)

    Retrieved from "http://www.advancedtubular.wiki/index.php?title=Lube_Machine_At_Part_Count&oldid=1792"