CNC Bender v12.1.1

v12.1 - August 14, 2013 Back to CNC Bender Software Updates

See CNC Bender Customer Service Page for an update.

FIX: FRB Clear Part Fixed

CNC Bender would save parts after a FRB clear by default in the c:\cnc\config folder. This was repaired so that it saves inside the the correct parts folder.

NEW: "Store Jog Commands When In Cycle Hold" Option

A new low-level option is added that changes the behavior of motion-controlled Jog commands when the control is in Cycle Hold. The "Store Jog Commands When In Cycle Hold" command will allow the bender to store and act on any jog command that was pressed immediately after entering CYCLE START. If the feature is disabled, then CNC BENDER will not store motion-controlled jog commands - but will clear them from the queue.

Other Pages

• Back to CNC Bender
• Back to CNC Bender Software Updates
• See CNC Bender Customer Service Page for an update.
• See CNC Bender General Information
• See Teach Mode
• See Custom Commands