VTube-LASER v2.8.1

Revision 2.8.1 Original Release Date: May 8, 2017 Latest Build: 70 - May 6, 2017 Back to VTube-LASER Back to VTube Software Updates (for LASER Mode) Download in updates the VTube-LASER Support Page

BUILD 70 - May 6, 2017

NEW: END OFFSET MODEL Feature

This adds a second model of the end point before it is offset. This allows you to visually confirm that the offset point (orange) is based on the correct datum point (yellow) when a Measured offste is used, and/or a ball probe is used on the end.

Other Pages

• Back to VTube-LASER
• Back to VTube Software Updates (for LASER Mode)
• See also VTube-STEP
• See also VTube-STEP Revisions
• See VTube-LASER Customer Support Page to download the latest version.
• See the tutorial on DCF - Dual Cylinder Fit
• See the tutorial on DCP - Diameter Cut Planes
• See VTube-LASER Cut Planes
• See How to Measure Tubes Attached to an Evaporator with the DCP Feature