VTube Communications With Transfluid Benders
This page describes the use of the VTube-LASER to Transfluid bender corrections. |
Back to VTube-LASER
Contents |
Transfluid SVNet Communications Protocol in VTube-LASER and VTube-STEP
As of version 3.0 build 456, we've embedded the Transfluid SVNET protocol in VTube-STEP and VTube-LASER. |
Configuring Transfluid tProject for Communications
Follow these steps in Transfluid tProject to set up communications for VTube-LASER and VTube-STEP |
tProject SET UP STEPS
STEP 1
Click on the blue button wrench/screwdriver button in the upper right corner of the user interface. |
STEP 2
Click on the Import/Export tab. |
STEP 3
Enter the set up data in the Import box.
|
STEP 4
Close the options menu with the OK button and check for the Supravision communications LED in the lower right corner of tProject. The LED should be green. |
How to Send New (Nominal) Data to tProject from VTube-STEP
The Transfuild tProject program can receive data for a part that has never been sent to it before from VTube-STEP. This allows a user to import a solid model of any tube, then send it to tProject. VTube-STEP
NOMINAL IMPORT
CORRECTIONS
|
|
OMCG Documentation from OMCG
This is the official OMCG Document (PDF - English) for setup and use of the OMCG SVNET protocol. Download the OMCG PDF Setup Document |
Other Pages
- See VTube-LASER
- See VTube-STEP