Revision: Benderlink for BLM 3.2

New Recognition of Variable Radius Bending

BLM benders can bend using draw bending or push-bending. BLM refers to push-bending as "variable radius bending." This version of Benderlink can recognize large radius push-bends and skip corrections to straights before and after push-bends. Also the bend angle of each push-bend is left untouched.

Benderlink indicates which values are not corrected by showing a bold red value on the screen. The BLUE radius values indicates the Benderlink knows that this is a variable radius bend.

Set the Linear Units for Conversion

Benderlink now shows two radio-buttons in the Measuring Center section that allow the operator to send the data to the measuring center in a consistent unit value.

Adjusted the BLM Data Output Accuracy

Bender data was being output as integer data.

The precision is now set to four places beyond the decimal.

Other Pages

Main Benderlink Wiki page
Main Benderlink for BLM Wiki page