CNC Bender v11-20090126

ENHANCE - Adjust General Dynamic Option Name - Feed-Bend Torque Limits

The Low Level names of dynamic options "Feed Torque Safe High" and "Feed Torque Safe Low" were adjusted for clarification.

The new names include "Feed-Bend" inserted in the beginning to be sure users understand that these values are used by the Processlist Builder to limit the feed axis torque during Feed-Bending only. These values have no effect on the torque of the feed axis for any other type of feed motion.

These are the options before the change:



These are the options after the change:



Upgrade Note: When upgrading to this version, it is important to remember to restore the dynamic options in low level in order to see this change take effect.

Warnings

WARNING! Do not set the HIGH value to any value above the recommended value - or the Feed Axis gear box or other parts of the carriage or carriage motion system could be damaged by high settings in the Bender Data page. "25%" is typically the maximum recommended value for extended-run. Any higher value may damage the machine and possibly void the warranty.

WARNING! Do not set the LOW value to any value below the recommended value - or the Feed Axis gear box or other parts may run-away due to high-errors. "10%" is typically the minimum recommended value for extended-run. Any lower value may damage the machine and possibly void the warranty.

Other Pages

• Back to CNC Bender
• Back to CNC Bender Software Updates
• Read about Push Bending
• Read about Push Bend Profile Tables