Revision: Benderlink for BLM 4

NEW - Completely Redesigned Interface

The interface has been updated and reorganized for easier reading with many new features for ease-of-use.

New - Quick Load and Merge BLM Buttons
New - Large LED numbers that indicate, in real-time, the byte count coming or going.
New - Large Monitor speed button for switching between MONITOR ON/OFF for waiting on measuring center commands.
New - Four new Date/Time labels show when data was last transmitted in any direction
New - Attention Grabber Logs that flash when the operator should know that something important just happened in the logs

ENHANCED - Updated Eaton Leonard Protocol Handling

This Benderlink now communicates with Eaton Leonard measuring centers using our new current-loop technology that is compatible with the Eaton Leonard legacy protocol. The new engine for communication handling is much improved over older versions.

NEW - New Help and Manual

The manual and help system are completely rewritten with new information that includes...

how to install Benderlink
how to install the Benderlink Ethernet Module
how to use the software - in much more depth

Read the online HELP

NEW - Edit the BLM YBC Data Before Sending the Corrected Data to the Bender

This new capability allows the user to fine-tune the corrections before they are sent to the BLM. For example, a 270 degree rotation can be switched to a -90 degree rotation with the press of an inversion button.

New - Check for Matching Part Number - Either ON or OFF

This new feature allows you indicate whether you want the part number to match between the BLM and measuringc enter:

UNCHECK: to setup new parts and ignore the part number during transmission.
CHECK: To prevent accidental mixing of two parts by making the two systems pay attention to the part name.

New - Confirmation PING for the Benderlink Module

If the Benderlink Ethernet Module responds to a PING, then it is ready for communication with Benderlink. This test makes testing networks much easier.