Vector Tube Data Center

SOFTWARE

Vector Laservision is typical software that runs on the Eaton Leonard Vector Tube Data Centers. Laservision software is one of the most logical for intelligent communications. For example, it does not recall data from benders during corrections loops unless a correction is needed. Also, its user interface leads operators through the inspection process using a simple step by step process.

COMMUNICATION Ports

Vector Tube Data Centers include 10 current loop ports that communicate using the legacy Eaton Leonard communications protocol. We have electronics that connect directly to the current loop ports on Vector Tube Data Centers. See the Benderlink Ethernet Module page for more information about our long-distance electronics.

APPLICATION Information

Eaton Leonard Vector Tube Data Center and BLM Benders	Download an applications datasheet for the Eaton Leonard Vector Tube Data Center and BLM Benders. See also Benderlink for BLM
Eaton Leonard Vector Tube Data Center and AddisonMckee Benders	Download an applications datasheet for the Eaton Leonard Vector Tube Data Center and AddisonMckee Benders. See also Vector Tube Data Center

These software packages can communicate with Laservision-based measuring centers:

• Benderlink for Addison
• Benderlink for BLM
• Benderlink for Chiyoda
• Benderlink for CNC Bender
• Benderlink for Crown
• Benderlink for Eaton Leonard
• Benderlink for FARO
• Benderlink for KEINS
• Benderlink for MiiC
• Benderlink for Pines