Feed Axis Faults During Feed Bending

From ATTWiki

Revision as of 20:19, 15 July 2009 by Mcone (Talk | contribs)

(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)

Jump to: navigation, search

During Feed-Bending it is possible to experience a Feed Axis Fault that is most often caused by one of two issues:

TOOL PAGE: The Centerline Radius values do not to match the bend die radii on the bender.

TOOL PAGE: The Feed Axis Adjust % is not set to the proper value in the Tool page.

If the Feed Axis faults especially on large angle bends, then one or both of these are probably an issue.

Retrieved from "http://www.advancedtubular.wiki/index.php?title=Feed_Axis_Faults_During_Feed_Bending&oldid=11347"