CNC Bender v11-200900915
From ATTWiki
ENHANCED - Pressure Die Advanced Timer Choice
The pressure die advance timer choice in the Processlist Builder is now dependent on the Pressure Die Assist setup in the Low Level General Dynamic Options list.
For example, if the PDA Mode is set to Follower / No Prox, then the Processlist Builder will switch to use the new PressureDieAdvanceWithTimer Without PDA command like this:
PressureDieAdvanceWithTimer Without PDA = tim2:500, cto:6000
ENHANCED - AutoLoader Timeout is Tied to Robot Timeout
The Robot Timeout value in the Low Level dynamic options is now used to control the AutoLoader timeouts.
Other Pages
- Back to CNC Bender
- Back to CNC Bender Software Updates
- See Cycle Hold
- See Hopper Logic
- See Processlist
- See Secondary Processlist
