CNC Bender v11-20091118

Type of Upgrade: FASTER BENDING The changes in this version are minor debugs to the November 4, 2009 version of CNC Bender - Speed optimizations. (See CNC Bender v11-20091104)

REPAIR- Final Bend Simultaneous Motion

If the final Bend Return Step Point is ZERO, then the standard "BendAbsolute" command is now called correctly without generating errors during AutoBuild. This switches the immediate move "Bend Absolute" off - which makes CNC Bender wait for the bend arm to completely return home before moving to the next step in the process.

REPAIR- Time Out Value for Bend Arm Return

The bend arm return timeout value was accidentally set to the Run Buttons timeout in the previous version. This has been resolved so that the axis timeout value is once again used.

Other Pages

• Back to CNC Bender
• Back to CNC Bender Software Updates
• See CNC Bender v11-20091104
• See CNC Bender General Information
• See Absolute Rotate
• See Absolute Rotate Offset Position
• See Final Feed Clearance
• See Mandrel Retract
• See Mandrel Retract Part Release