CNC Bender v11-20091229

Type of Upgrade: Optimization and New Feature The changes in this version are designed to make CNC Bender more accurate and run faster.

ENHANCE- Updates to CNC Processor to improve motion command logic

There were circumstances were incremental motion commands could be issued twice when only one command was necessary. This version of CNC Bender removes the potential for double calls to incremental motion commands

CHANGE- PreBend Rotate to Start Angle User-Interface Change

The PreBend ROTATE TO START ANGLE feature is now only available in the PreBend Dynamic Options list This reduces confusion so that the operator knows that the feature is available in a single location.

NEW - Tube Mandrel Check and Destroyer Feature

CNC Bender can now automatically check for the existence of a broken mandrel after a mandrel extraction. If the mandrel is broken, then CNC Bender process list logic requires the operator to place the tube in a tube destroyer to crush the tube to prevent it from being used in other machinery in the cell.

Other Pages

• Back to CNC Bender
• Back to CNC Bender Software Updates
• See CNC Bender General Information
• See Final Feed Clearance