|
CNC Bender is ready to LEARN if you're ready to TEACH!
Teach Mode allows you to Jog any axis or actuator into position while CNC Bender "watches" and remembers your move exactly as you performed it. Teach the bender your knowledge for difficult transitions between bends.
The power of Teach Mode shines through with its ease-of-use. Actual reactions of new operators prove that this is an easy-to-learn Teach Mode system. (We've been told that our system is one of the easiest to use.) Of course, "easy to learn" translates into usable and productive over the long-haul.
- OVERVIEW of USING TEACH MODE
- Enable Teach Mode inside the options list for bend 1. (See Screen 1)
- Power on and Cycle Start the bender
- Press AUTO mode.
- Activate the Teach button in the Control Mode bar. (See Screen 2)
- Load and bend the part
- After bend 1 is finished, the dies will open, and CNC Bender will enter STEP mode, and display the Teach Mode menu. (See Screen 3)
- Teach the bender up to 10 Custom Commands - each command can contain any number of simultaneous jog motions. (See Screen 4)
- Exit the Teach Mode window and finish bending the part.
- OTHER THINGS TO KNOW
- Teach in PreBend immediately after you chuck the part and press the run buttons.
- Control extra moves in PostBend using the final bend's Custom Commands.
- Jog an axis into position while CNC Bender "watches" your move.
- Jog an axis to its zero position
- The learned moves are held in objects called Custom Commands (see below).
|
 Screen 1: Enable Teach Mode individually for each bend
 Screen 2: New TEACH speed button in the Control Mode bar
 Screen 3: Teach Mode activates after a Teach Mode Section was encountered during bending
 Screen 4: Custom Command Editor during Teach Mode
|
NEW - TEACH MODE
