CNC Bender v12-20100414

ENHANCED - Benderlink Changes START Position Adjustment

Benderlink is enhanced to correctly change the START position of the carriage during correction if that feature is switched on.

REPAIRED - Benderlink Database Transfer Setup Clear

The CNC Bender database was corrupted when Benderlink users pressed the "Apply and Close" button without first having made a correction. The result was a CNC Bender setup that would cause major issues in CNC Bender. This issue has been corrected by automatically updating the Adjusted database when Benderlink shows on the screen. There is no possibility that the the setup database can now be cleared improperly.

REPAIRED - Single Radius Carriage Shifting

Single radius carriage shifting is now re-enabled in this version.

REPAIRED - Direct Axes Jog Buttons Stick Down

If the Immediate Message box displays while an operator is pressing a JOG+ or JOG- button in direct axes jog mode, then CNC Bender would never allow the jog button to come up. This has been resolved.

REPAIRED - Automatic Feed Adjustment During Part Load

The automatic feed adjustment feature works by advising operators that incoming part data was from another bender with a different bed length. We discovered and solved problems with a couple of options in the Tool page.

Other Pages

• Back to CNC Bender
• Back to CNC Bender Software Updates
• See CNC Bender General Information
• See Teach Mode
• See Custom Commands