CNC Bender v12-20100611
From ATTWiki
|
|
|
Contents |
NEW - CNC Bender Direct-Axis Jog with Joystick or Pendant
|
CNC Bender can now respond to a joystick or pendant buttons when direct-axis jogging.
|
|
NEW- Direct Axis Jog from INPUT Options
|
The low level general options list contains three new options: ENABLE, JOG+ Input Name, JOG- Input Name. If this feature is enabled, then the input names are used to lookup the input points in the CIO dictionary. |
|
REPAIRED - Automatic Feed Adjustment During Part Load
| The automatic feed adjustment feature works by advising operators that incoming part data was from another bender with a different bed length. We discovered that two of the Tool page options were not being changed properly. This is corrected. | |
Other Pages
- Back to CNC Bender
- Back to CNC Bender Software Updates
- See CNC Bender General Information
- See Teach Mode
- See Custom Commands
