CNC Bender v12-20100611

NEW - CNC Bender Direct-Axis Jog with Joystick or Pendant

CNC Bender can now respond to a joystick or pendant buttons when direct-axis jogging. Direct axis jogs using external devices is active in the MANUAL and TEACH MODE pages. In the MANUAL page, the joystick or pendant is used only when the Direct Axis jog button is activated. In the CUSTOM COMMAND EDITOR page, the joystick or pendant is used only when the TEACH button is activated. In the CUSTOM COMMAND EDITOR in TEACH mode, the joystick and teach-pendant can control both SERVO and DIRECTIONAL-VALVE actuators. In other words - they can control all actuators.

NEW- Setup Options for Direct Axis Jog from INPUTS

The low level general options list contains three new options: ENABLE JOG+ Input Name JOG- Input Name If this feature is enabled, then the input names are used to lookup the input points in the CIO dictionary.

Other Pages

• Back to CNC Bender
• Back to CNC Bender Software Updates
• See CNC Bender General Information
• See Teach Mode
• See Custom Commands