CNC Bender v12-20101102

NEW Splash

CNC Bender has a new splash screen

NEW - Dedicated Timer in CNC Processor for Joystick Jog

A new timer is added to CNC Processor to regulate the response to joystick-type jog motion. This allows for steady jog motion no matter what other process the processor performing.

NEW - Default Jog Speed in Axislist Configuration

The default jog speeds for each axis are now set inside the main.axislist configuration file. The speeds are reset to default: When Processor runs the Init Axis processlist When Processor senses a change between operation modes (manual, step, auto) When exiting the Custom Command Editor Other Notes: If the default jog speed value is not present in the main.axislist file for any axis, then the value defaults to "20". If a default jog speed is negative, it is reset to the positive value. If a default jog speed exceeds the maximum speed for an axis, then it is reset to the maximum speed.

Other Pages

• Back to CNC Bender
• Back to CNC Bender Software Updates
• See CNC Bender General Information
• See Teach Mode
• See Custom Commands