CNC Bender v12-20110128

v12-20110128 Back to CNC Bender Software Updates

NEW - Process List Commands Can Ignore STEP Mode

Some commands don't move the actuators on bender. They only setup the bender. Now these commands can be told to not PAUSE during STEP MODE. This will reduce the number of run-button or foot-pedal steps required to run through a part on the bender in STEP mode. The COMDEF Editor has a new "Ignore STEP Mode" checkbox for each COMMAND.

ENHANCED - Teach Mode Button Can Be Invisible

Some benders don't need TEACH Mode, so the Teach Mode button can be made invisible by enabling a switch in the low level options list.

ENHANCED - Output Diagnostic

The Output Diagnostic was enhanced with 32 points visible on the screen, and larger controls.

Other Pages

• Back to CNC Bender
• Back to CNC Bender Software Updates
• See CNC Bender General Information
• See Teach Mode
• See Custom Commands