VTube-LASER v1.63

Revision 1.63 Back to VTube-LASER

NEW: Select and Configure any number of Reports

The Report menu was redesigned so that operators choose from a list of report templates to show any one of several reports. Give each report template a name that is linked to an external report template file. Change the list (Add, Delete, Move the template up or down). Edit any template in the included Notepad++ editor (installs with v1.63). Explore the folder that contains the templates. There is no limitation on the number of templates allowed. The report template setup is stored local to the computer (not in project files).

NEW: Added LENGTH grid in the Inspection Menu

The new Length grid shows the MASTER, MEASURED, and differences between the two. Use these values to know how much to change the pre-bending material cut length. The Crosscheck values were moved into this grid. (Crosscheck is a measure of the straight line from end A to end B.)

Other Changes

Updated the graphics engine for faster redraws. Added more report values - master length, measured length, delta between measured and master, bender setup LRA Updated the manual and help file.

Other Changes

The A End and B End OFFSETs other than ZERO caused a problem where end-scans would never be qualified. This has been resolved in this version.

Issues with this version fixed in newer versions

No known issues

Other Pages

• Back to VTube-LASER

VTube-LASER Training Video - How to perform effective end scans.