VTube-LASER v1.62

Revision 1.62 Back to VTube-LASER

ENHANCED: End Scans Faster + New Progress Window

Analysis of end scans is now at least twice as fast as in version 1.61. When end-scans are taking more time than a few seconds, a progress window will display.

NEW: Scan Rate Types: Timer or Distance

Now all scan rates are determined by either a TIMER or a DISTANCE. For end-scans, use a timer and set the timer value to 0 milliseconds. For cylinder scans, you can use DISTANCE and set the Cylinder Scan Distance to whatever value is convenient for separation.

NEW: Multiple Point Qualification End Scan

VTube-LASER now uses multiple points to qualify the end-scan. This gives it better protection against outlier points. A new End-Scan Fit window gives information about how many points were used in the end-trim, and the span of all the point positions. Higher point counts with lower spans indicate a better data set for end-trim.

REPAIR: Diameter and Wall Detection for STEP Mode

See VTube-STEP v1.62 for details.

Other Changes

The A End and B End OFFSETs other than ZERO caused a problem where end-scans would never be qualified. This has been resolved in this version.

Issues with this version fixed in newer versions

Diameter measures now use the Cylinder scan rate filter setup values. (Fixed in VTube-LASER v1.63)

Other Pages

• Back to VTube-LASER

VTube-LASER Training Video - How to perform effective end scans.