CNC Bender v12-20110525

v12-20110525 Back to CNC Bender Software Updates

ENHANCED - Changes to Logic

Chuck Close/Open Skip in Post Bend - for special teach mode unloading Processor checks for special internal command in processlists - which is required even in custom processlists: [BEGIN RUN AGAIN] Allow mandrel to advance in MANUAL page even if clamp or pressure die are closed.

NEW - SmartInspect Configuration File Added

A new configuration file "loggingsetup.cfg" is added to the cnc\config folder. The new logging setup allows for debug logging in both CNC Processor and CNC Bender. The logging setup features for CNC Processor were previously in the CNCProcessor.cfg file.

Other Pages

• Back to CNC Bender
• Back to CNC Bender Software Updates
• See CNC Bender General Information
• See Teach Mode
• See Custom Commands