CNC Bender v12-20110525

v12-20110525 Back to CNC Bender Software Updates

ENHANCED - Changes to Logic

Chuck Close/Open Skip in Post Bend - for special teach mode unloading Processor checks for special internal command in processlists - which is required even in custom processlists: [BEGIN RUN AGAIN] Allow mandrel to advance in MANUAL page even if clamp or pressure die are closed.

ENHANCED - Changes to Loading

CNC Bender can now be loaded from the Start Menu at Windows boot without failing to find the hardware key

FIX - Default Mode Value When Option is in Toolbox

The default mode index for dynamic options is now always the first item when in the toolbox

ENHANCED - COMDEF Editor - Previous / Next Buttons

Previous / Next buttons are added to quickly move between COMDEF files. No more open dialog is needed! The buttons use the COMDEF list in the previous tab to quickly locate the next or previous file to load. If there is nothing in the COMDEF list, then COMDEF Editor will load the list first. The CIO list to the left will now always sorted.

Other Pages

• Back to CNC Bender
• Back to CNC Bender Software Updates
• See CNC Bender General Information
• See Teach Mode
• See Custom Commands