VTube-LASER v1.69

Revision 1.69 Back to VTube-LASER Back to VTube-STEP

ENHANCED: FARO Arm Measure Setup

Measure Setup allows operators to control more FARO server menus, and shows all the current FARO arm and probe data in a grid below the setup buttons.

ENHANCED: Arm Values Can Be Added to Reports

Many report value fields were added to the report logic. These fields can show the arm and probe calibration and accuracy values. Add these to any report or use them to create a custom report. This allows the current state of the arm to be printed with the report - proving that the arm was calibrated during measurement.

NEW: Cut Plane Question

VTube now asks if you intend to establish a cut plane immediately after the arm is connected to VTube-LASER.

NEW: VTube-LASER Programmer Mode

This new mode allows customers to purchase a license of VTube-LASER for programming VTube-LASER projects remotely where there is no need to connect to the FARO arm. The license price for Programmer mode is significantly less expensive.

Other Changes

VTube was adjusted to handle discovered Transfluid data file floating point requirements for diameter and radius. (To prevent load failure, Transfluid requires only two places beyond the decimal for these values - no more.)
VTube can now import a Transfluid file as MASTER data.
The arm as mouse speed is now controlled in the FARO hardware configuration menu - not in VTube-LASER System Options.

Issues with this version fixed in newer versions

No known issues

Other Pages

• Back to VTube-LASER

VTube-LASER Training Video - How to perform effective end scans.