VTube-LASER v1.70

Revision 1.70 Back to VTube-LASER Back to VTube-STEP

ENHANCED: Inspection Mathematics

The inspection mathematics is more accurate and is now better able to work with the short straights in split bends (where VTube combines the bends to make a single large bend).

ENHANCED: Arm Values Can Be Added to Reports

Many report value fields were added to the report logic. These fields can show the arm and probe calibration and accuracy values. Add these to any report or use them to create a custom report. This allows the current state of the arm to be printed with the report - proving that the arm was calibrated during measurement.

NEW: Cut Plane Question Reminds Users To Consider Cut Plane

VTube now asks if you intend to establish a cut plane immediately after the arm is connected to VTube-LASER.

NEW: VTube-LASER Programmer License Mode

This new mode allows customers to purchase a license of VTube-LASER for programming VTube-LASER projects remotely where there is no need to connect to the FARO arm. The license price for Programmer mode is significantly less expensive.

Other Changes

Transfluid fails to load the diameter and radius values if the values use more than two places of accuracy beyond the decimal. So now VTube is careful to use only two places of accuracy beyond the decimal for those two values.
VTube can now correctly import a Transfluid file as MASTER data.
The arm as mouse speed is now controlled in the FARO hardware configuration menu - not in VTube-LASER System Options as in previous versions.

Issues with this version fixed in newer versions

No known issues

Other Pages

• Back to VTube-LASER

VTube-LASER Training Video - How to perform effective end scans.