VTube-LASER v1.73

Revision 1.73 Back to VTube-LASER Back to VTube-STEP

ENHANCED: Fine Tune for FARO Edge ScanArm

The FARO Edge uses a different scan rate than the older arms. VTube-LASER was adjusted to work with the FARO Edge arms.

ENHANCED: Cut Plane Offset Reset

The Cut Plane Offset can now be changed without remeasuring the Cut Plane.

ENHANCED: Cut Plane Offset Value

The Cut Plane Offset Value is now displayed above the Cut Plane icon.

NEW: Split Bend Model Display

New Split Bend model geometry is included on the screen when measuring split bends in order to visually verify the calculations.

NEW: XYZ INTERSECTION STRAIGHT LENGTHS

A new chart is included in the inspection report that shows the lengths between intersections for both the MASTER and MEASURED as well as the Delta between the two.

Other Changes

A graphics model memory leak was repaired where project files continued to grow in size every save and load. This change makes loading and saving much faster in VTube. The Split Bend logic was enhanced and Split Bend envelopes were enhanced. New confirmation menus for when pressing STOP or CLEAR the measure process. This prevents accidentally canceling measuring processes.

Issues with this version fixed in newer versions

No known issues

Other Pages

• Back to VTube-LASER

VTube-LASER Training Video - How to perform effective end scans.