CNC Bender v12-20111130

v12-20111130 Back to CNC Bender Software Updates

ENHANCED - PDA Motion in Test Bend

The PDA gearing is now properly set if the VG (Realtime Variable Gearing) feature is off or on. The PDA returns home when the operator presses All Dies Home.

REPAIR - Tube Support During Home

The Tube Support now stays DOWN during homing when the tube support UP enable feature is disabled.

New - [Enable Axis] Internal Command

This command is used by the process list builder to enable the Feed axis even when the axis list is setup to only enable when moving. This ensures that the Feed axes with low gearbox ratios stay in position when loading the tube.

Other Pages

• Back to CNC Bender
• Back to CNC Bender Software Updates
• See CNC Bender General Information
• See Teach Mode
• See Custom Commands